NRC releases a PLUG & PLAY fender eliminator kit for the Ducati Scrambler Sixty2! If you are looking to remove the rear fender, this is the kit for you! Our kit is sold as turn signals only, as well as a complete fender eliminator solution with a license plate bracket included. If you want to keep the stock license plate, no problem! You can order just the signals with splash guard -- or add the license plate bracket and tuck it up underneath the bike.
Our plug & play kit saves you time and money on installation, and lets you plug right in and ride on!
Installation Instructions
Disconnect white connector for license plate light located in front of swing arm, and re-route underneath bike
Remove wire from two cable clamps under swing arm
Remove 3 hugger bracket mounting screws and take hugger off
Remove splash shield and stock fender
Unplug connectors and remove entire fender
Remove storage box from underneath seat
To mount belly pan and NRC turn signal bracket to the bike, use 2 stock bolts for lower mounting holes, and 2 supplied M8 bolts underneath tail light. Turn signal bracket sits on top of belly pan
Route all of your wires under seat and plug into stock harness, making sure both signals and plate light are working
Mount your license plate to the belly pan, and then re-install storage bin
