Close

VORTEX FUEL AND IGNITION CONTROL X10 ECU CDI YAMAHA YFZ450R YFZ450X 2009-2019

Rating:
100% of 100
SKU
VX_3
Part Number
VTU-374R
$694.99
x
Images are for representation purposes only. Actual Product may differ

The Vortex ECU for the YAMAHA YFZ450R is like our CDI and EFI Interceptor rolled into one module. The ECU controls not only Spark timing and Voltage output but also Fuel Metering and other engine management functions. The result is more power, better power, easier starting and ultimately faster lap times. This unit comes pre-programmed with 10 Performance Fuel & Spark timing maps as well as having 3 additional switches for user trimming (adjusting) of Fuel in Lo, Mid and Hi throttle openings. The ECU plugs directly into the bikes standard wiring harness and interfaces with all the standard engine sensors such as ECT (Engine Coolant Temperature), IAT (Intake Air Temperature), MAP (Manifold Absolute Pressure), TPS (Throttle Position Sensor), CPS (Crank Position Sensor) to adjust fuel and spark timing for optimum power delivery in all weather, altitude and load conditions. Performance gains vary depending on throttle and RPM points however typically gains are in Top End power and Bottom End throttle response is expected from the Power settings and a smoother more tractable or rideable power from the Traction settings. We have done extensive work to include tune parameters which improve starting and almost eliminate the flameouts experienced with EFI mx bikes. All of the development work is done for you! All that is left is for you to do is chose a setting that best suits your riding style or track conditions and ride!

The ECU is also fully programmable (Software not supplied-available at additional cost) with parameters that are far more extensive than those found in any factory setting tools, such as Rev Limits, Throttle Enrichment & Decay time, Fuel timing, High Resolution Mapping, Dwell Timing, Voltage Output and trim tables for cold starting, air intake, baro, battery voltage , etc... In addition there is real time logging & graphing of many parameters. The ECU connects to a PC through our USB/Power adaptor which requires no external power source.

More & Smoother Power
Pre Programmed with 10 Performance Fuel & Ignition maps (changed by adjustable dial) developed on the Dyno & Track, all the work is done for you!
Instant Plug in Performance (replaces standard ECU with no mods to wiring required)
3 fuel trim switches to adjust fuel mapping by +12.5% to minus 10% in Lo, Mid and Hi throttle opening
Adjustments made using a screwdriver and switches provide visual feedback as to changes made
V-Boost - Programmable Voltage Boost Circuit for maximizing Spark Energy across the entire rev range
Higher Rev Limit (where required)
Robust design, fully waterproof with o-ring sealed switches
Diagnostic Flash codes, tests for sensor faults and flashes codes to FI light
Rubber Mounting Boot + Brackets supplied (where required)
Race Proven reliability
Handlebar switch (Optional upgrade at additional cost)- Dynamic Map Selection, easy installation with original plugs
Fully Programmable (PC Software - not included, available at additional cost)
Interface to Vortex Data Acquisition System and Wideband A/F Sensor

Write Your Own Review
You're reviewing:VORTEX FUEL AND IGNITION CONTROL X10 ECU CDI YAMAHA YFZ450R YFZ450X 2009-2019
Your Rating
Like us on Facebook!

1.Like us on Facebook :

2.Enter Your email address below :